Finish that Barn Quilt Out!
Updated: Nov 5, 2023
I am one of the people that are a perfectionist. Especially when it comes to my Barn Quilts. I am not one to take a short cut, skip that extra coat of paint or ignore that little touch up that needs done. Why? Because I want my customers to get what they pay for and my reputation matters.
So why trim out your MDO? Not only does this protect your work, it gives it the finished look that customers appreciate too. I am attaching a picture of what CAN happen if you use exterior paint with a sealer, and do not trim in your edges. This also applies if you are using any grade of plywood. It is layered wood and these can deteriorate and peel or separate over time.
What steps do I follow? Glad that was on your mind. First off I have to get wood strips ripped down to the size I need to edge my wood. My "guy" that cuts my MDO at the local supplier also does these for me. This is a major help since they really don't make the perfect width for the MDO I use. If I am using 3/4" MDO, regular screen molding works.
The steps are pretty easy and if you have my books, Barn Quilt Addiction, the tools needed are featured in this. It is pretty easy process although I will be the first to admit - this is the part I hate the most.
Steps:
1) Cut your trim piece to length
2) Use a good caulk that is PAINTABLE and an exterior one. I get mine at Harbor Freight.
3) Don't cut the tube tip too large, a little goes a long way.
4) Place a bead of caulk on the edge and use something such as a plastic credit card to spread evenly.
5) Pre-nail your trim piece as shown in the video before applying to the edge.
6) Nail about every 4-6" to secure
7) Wipe excess caulk off the face of the BQ with a dry cloth.
8) Make sure any little gaps are sealed with the caulk.
I usually wait about 30 minutes before I proceed with priming the board. It does dry pretty quickly.
When I am drawing my pattern off, I always start from the center of the board and work my way out. The trim is usually "extra" width that I just ignore and paint accordingly based on the pattern. That little 1/4" on each side just falls into place but if you start measuring from the edge across to make you pattern, you are asking for a headache!
So I hope this video is helpful and I appreciate feedback. If there is something you want to learn or see demonstrated, I will do my best. Just ask!
Carry On The Addiction,
Talara






Any ideas where to get 1/2" screen trim for the frame? My lowes only has 3/4". Or is caulking enough coverage?
Hi Talara, I am a beginner and was wondering if the trim has any impact on the design as far as size goes since you are adding an inch to the width and length with half inch tim pieces? Is it small enough to not make a noticeable difference?